Water pollution, in our lives is also common! Among them, coliform bacteria is a common bacteria in medical wastewater, which is a problem that we cannot ignore. This chapter water quality online monitoring equipment manufacturers to understand together with us the causes and prevention of excessive coliform bacteria in wastewater.

It is normal to have coliform bacteria in domestic wastewater. What is the cause of excessive coliform bacteria in wastewater? Mainly by the following situations:

1.When the pipeline was under construction, the construction party sealed the pipeline, but some wooden planks existed inside the pipeline were not found by the construction party at that time, and the dirty things stuck to the pipeline after a long time, resulting in pipeline blockage and wastewater discharge problems;

2.The amount of medicine in the disinfection pump is not proportional to the discharged wastewater, resulting in insufficient concentration, and also the cause of excessive coliform bacteria;

3.The discharge of wastewater has been increasing, but the sewage system used by the wastewater has not been expanded in time, resulting in the overloading of the wastewater discharge system.

4.However, what we need to do is to investigate whether there is medical wastewater in the drainage unit, and also consider the source of wastewater connected to the pipe network. If the access wastewater exceeds the standard or the medical wastewater has not been pre-treated, it is normal for the coliform bacteria in the wastewater to exceed the standard! Remember! It is very important to do medical wastewater online monitoring!

If we want to avoid using water contaminated with coliform bacteria, we need to do some control!

It is necessary to install relevant water quality monitoring and treatment in the wastewater discharge outlet. WECT-900 water quality Coliform online analyzer uses the international standard method, and the principle that the light signal change after the enzyme and bacterial culture reaction is proportional to the total amount of bacteria or coliform bacteria in the sample is reflected.

What should I do if I have to drink infected water?

If the coliform bacteria in domestic water exceeds the standard, it cannot be used directly. Because coliform bacteria is very harmful to the elderly, children and weak people. Even if it is boiled, it is not eaten. If there is no way, you must drink the infected water, to high temperature disinfection, or under the guidance of professional personnel after disinfection, filtration, treatment before use.